$27.00
Great, until I reached the center of the 70 inch and it bowed damaging the edge of my wood. It needs center stabilization, so use clamps!! I also dropped it later, and it cracked in half. Not the best mold. Probably half my fault for not anticipating these problems....
United StatesThe routing jig worked well. The problem that I did have was with the 13/16" Auger Bit that I purchased. A 3/8" drill motor will not drill the required hole in walnut. I had to use my 1/2" drill motor, which was fine. However, the auger bit only has a 1/4" shaft and the torque from the drill motor caused the shaft to twist severely. Yes, I had the drill chuck very tight. I would suggest that you sell auger bits with a 3/8" shaft in the future. Thanks.
United States
